Instructions for firmware Pantum M6700 M7100 version 3.6.0.9 and 3.6.1.x (40)

[dangmien]

Instructions for firmware M6700 M7100 version 3.6.0.9 and 3.6.1.x (40)

Pantum M6700 M7100 firmware version 3.6.0.9 and 3.6.1.x (40)

1. The firmware version must be at least 4.1
   
   
2. It is necessary to remove the cover on the USB cable connection side.
   
   
3. Close (with tweezers) the BOOT1 (CN2) contacts and start the printer
   
   
   
   
4. The device should start in Bootloader Mode. You can verify this by clicking the “Get Printer ID” button in the program.
   
   
5. Next, click “Upgrade Firmware” and select the file M6500_2A_Bootloader.bin
   https://nochip.ru/downgrade/M6500_2A_Bootloader.bin
   
   
6. After filling the green bar at the bottom, turn it off (hold down the power button for 5 seconds, or disconnect from the power supply). Then, turn on the device again.

 

[sola]

Q0s2VzAwMDA0MDo6MkMwNzIxMDQ6OkFDOkM1OjFCOjJBOkMwOjE3OjozLjMuNy45JFNJR2U4N2I5MGR
mYTRiZjM2MDhkY2EwNDFjMDA4YTcwMTk4OjpEQVRBOk1vbiBKdW4gMjIgMTY6NTM6MDMgSEtUIDIwMj
A6OjI1Njo6TTcxMDBEVwA6OjMuMy43LjkAOjo1LjI=